After printing your label, tear the full sheet in half along the perforation line. Flip the label sheet over so the printed side is face down.	Using the pull-tab, peel and remove the backing sheet from your label. The 2 tab holes and the centre disc hole should pop out during this process.	Place the label sheet printed side down onto the applicator, using the tab pins for proper alignment.	Close the applicator lid over your CD/DVD label.
Place your CD/DVD onto the applicator, using the centre guide to help align your disc. Holding your CD/DVD along the outside edge will ensure your disc will not be damaged.	Apply downward pressure to your disc, securing it to your label. Take care not to scratch the written surface of your CD/DVD disc.	Leaving the applicator closed, lift and remove the disc by inserting finger into the finger notch (from above or below) and pulling the labeled CD/DVD up and away from the backing sheet.	Store the finished disc in a jewel case or storage device.

index | jewel case spine | mini cd | ebusiness disc I jewel case song booklet I jewel case inserts