CreateIt Quick Start


Standard jewel case back w/spine insert & standard front insert

After printing your back insert for your standard jewel case, remove the insert by tearing along the outside perforations.	Flip the sheet over so the printed side is face down. Fold the spine flaps up at a 90º angle along the score lines.	Remove the disc tray your standard jewel case by carefully lifting it out of the locking tabs.	Place your folded insert into the bottom of your jewel case.

Replace the disc tray into your jewel case. Locking one end at a time will help keep the spine flaps in place.	If you have printed a standard front Insert remove it by tearing along the perforations.	With your jewel case open, slide the front insert face down under the jewel case lid tabs.	Close your standard jewel case and inspect your printed inserts. Make any necessary adjustments by repeating the appropriate steps.
Slimline Jewel Case Front Insert(s)

After printing your Front Insert for your slimline jewel case, remove the insert by tearing along the outside perforations.	With your jewel case open, slide the front insert face down under the jewel case lid tabs.	Close your slimline jewel case and inspect your printed insert. Make any necessary adjustments by repeating the previous steps.	To use the second Front Insert for your jewel case, remove the insert by tearing along the inside perforations. Be sure to tear at the extended top edge (A). Repeat steps 2 and 3 to finish.